5 60 60 ° c. 30 60 60 ° c. Engine start batteries, electric bicycles / motorcycles / scooters, golf carts / trolleys, power tools...
Solar and wind energy systems, motor homes, caravans... 3.2V 310Ah Battery4 Screw8 Copper sheet3.3.2V 280Ah Battery4 Screw8 Copper sheet4. This product is brand new and original, and the battery pack can be DIY if the voltage is normal. 2.56 ± 0.10kg. Long life cycles 4000 times for 12v 24v solar energy storage solar power ups Engine starter battery, electric bike / motorcycle / scooter, golf cart / carts, power tools... Solar and wind power system, rv, caravan..
3.2V 135Ah battery4 Copper sheet Screw + cushion. EV 3.2 V 105Ah. 3.2V / 105Ah battery 4 Screw 8 Copper sheet 4 Cable copper sheet 8. Sending list: 3.2V 105A battery (Including M4 screw + copper connection). Operation Temperature and relative humidity Range.Storage temperature for a long time. Rated Capacity at 0.5CMin. After standard charge, the capacity shall be measured on 0.5C discharge till the voltage discharge to 2.5V. Charging and discharging battery as blew conditions 0.5C standard charge to 3.65V end-off 1.0C standard discharge to 2.5V cut-off Continuous charge and discharge for 2000 cycles, the capacity will be measure after the 2000 th cycle.
The battery to be charge in accordance with standard charge condition at 25±5? Then storage the battery at an ambient temperature 25±5? Measure the capacity after 28 days with 0.5C at 25±5? The battery to be fully charged in accordance with standard charge condition, then drop the battery which the positive and negative extremes face down from a height of 1,5m onto a concrete floor, observing for 1h.
After standard charging, fixed the cell to vibration table and subjected to vibration cycling that the frequency is to be varied at the rate of 1Hz per minute between 10Hz and 55Hz, the excursion of the vibration is 1.6mm. The cell shall be vibrated for 30 minutes per axis of XYZ axes. Fully charged the battery in accordance with sta ndard charge condition, the battery is to be cru shed between a flat plate and a 75mm semicyli nder, the length of the semicylinder should great er than the size of the cell. The extrusion spee d is 5±1mm/s, Continuous to applied force on b attery, stopped until a pressure reading of 200K N is reached on the hydraulic ram or the cell v oltage reaches at 0V or the deformation quantit y reaches at 30%, observing 1h. 3.2V 102Ah battery M6 Screw Connecting piece.
Size: 16011850mm Weight: 1950g±30g Note: Long-term storage at -30°C-60°C should not exceed half a year, and it must be charged once every half a year. The battery with a protective plate is charged once every 3 months.
Assembling Battery Pack: Do not allow impact, high temperature or contact with sharp parts during battery assembly 1. It is strictly forbidden to directly solder leads or equipment to the battery· 2 The pole piece should be spot-welded to the battery first when welding the lead wire. It is directly welded to the electric heat. The heat generated will damage the electrical isolator and insulator. There should be enough insulating layer for safety protection between battery and lead.The packaging of the battery should not cause a short circuit that could cause a fire in the garden. It is forbidden to dismantle, do not dismantle any electrical port. Demolition of the power plant will cause short circuit inside the battery, lead to fire, explosion, harmful gas or other problems. 2 The electrolyte has apricot 5.
In case the electrolyte gets on your skin, you should immediately rinse with clean water and ask for help. The product came very well packaged. This item is in the category "Consumer Electronics\Multipurpose Batteries & Power\Rechargeable Batteries".The seller is "oneclickmall1" and is located in this country: CN. This item can be shipped to United States.